Ball Vice

MstrsMntrx's Ball Vice made by her Slave Sirgntlman
First.. this is important Use at your own discretion. This is a great device for mind games, but can be a real ball breaker

Go to local co-polymer dealer, plastics in yellow pages. Have two half inch thick pieces of LUXENE (note from Domina--Lexan?)cut six inch by 5 inch do not use plexiglass - will break - BAD THING!

On one plate centered at the end, one and a quarter inch back from edge drill a hole for a quarter inch bolt. On the opposite end of the plate drill two holes for three sixteenth bolts, pull the top plate to the side, place balls in, scrotum through guide pins bring plate back around, slide down guide pins till snug, spin wing nut down.

As you slowly turn wingnut, slave physically and visually becomes aware of his terrible situation...lol

Other things can be added such as washers, rubber gaskets over guide pin hols to keep scrotum meat from being pinched. And a metal guide ring in reciprocating hole for quarter inch bolt, but these are just refinements. I like to place this on my slave and slowly tighten to a pleasing point and while he's dwelling on that I switch to another form of tease or torture coming back to vice to screw down slightly on occasion.. Real mind trip!

Question on Procedure: This might be a silly question....but is he Upright when you attach it...? Or....turned over? I mean..where do the *other* parts go..?

His cock goes above the vice, he's sitting, laying, or standing